Registering the File Systems

Registering the File Systems

Figure 9.5: Registered File Systems

When you build the Linux kernel you are asked if you want each of the supported file systems. When the kernel is built, the file system startup code contains calls to the initialisation routines of all of the built in file systems.

Linux file systems may also be built as modules and, in this case, they may be demand loaded as they are needed or loaded by hand using insmod. Whenever a file system module is loaded it registers itself with the kernel and unregisters itself when it is unloaded. Each file system's initialisation routine registers itself with the Virtual File System and is represented by a file_system_type data structure which contains the name of the file system and a pointer to its VFS superblock read routine. Figure  9.5 shows that the file_system_type data structures are put into a list pointed at by the file_systems pointer. Each file_system_type data structure contains the following information:

Superblock read routine

This routine is called by the VFS when an instance of the file system is mounted,

File System name

The name of this file system, for example ext2,

Device needed

Does this file system need a device to support? Not all file system need a device to hold them. The /procfile system, for example, does not require a block device,

You can see which file systems are registered by looking in at /proc/filesystems. For example:

      ext2

nodev proc

      iso9660